Faucet & Sink Repair
Repair drips, weak flow, stuck shutoff valves and leaking outdoor spigots.
A humming disposal that will not turn is jammed. A silent one has lost power. A dripping one has a bad seal. The repair differs for each. A disposal that is leaking under the sink or backing up into the dishwasher should be shut off and reported to the 24/7 line.
Never put a hand in a disposal. Use the tools in the steps below.
Turn off the switch and the power to the disposal. Under the unit, there is a hex socket in the center of the bottom. A hex key, often an Allen wrench included with the unit, turns the flywheel back and forth to free the jam. Look inside with a flashlight and remove any object with tongs or pliers, never a hand.
With the blades turning by hand, push the red reset button underneath the unit. If it trips again, the motor may be failing.
Where the water appears tells you what failed. A leak from the top, at the sink flange, is a failed gasket or putty seal and the unit has to come off to reseat it. A leak from the side where the dishwasher hose or the drain pipe connects is a loose clamp or a worn gasket.
A leak from the body, below the grinding chamber, means the housing has cracked or the internal seal has failed. That usually means replacing the unit.
Many Maricopa County homes are on city sewer, where disposals are common. If your home is on a septic system, ask before installing one, since the added solids affect the tank.
Condos and rentals often have rules about appliances. Check with the association or the landlord before replacing a disposal.
Disposal work ranges from a simple unjam to a new unit with new plumbing.
Ask whether the quote includes the new unit, the mounting kit and the removal of the old one.
A smell from the disposal comes from food that sticks to the walls of the chamber and the underside of the flapper. Grinding ice, citrus peel and a little dish soap, then running cold water, cleans it. A disposal that drains slowly may have a clog in the trap or the drain line past it.
Grease, coffee grounds, pasta, rice and fibrous stalks cause trouble. They clump in the drain and make clogs. Run plenty of cold water while grinding and for a few seconds afterward.
Most disposals are mounted under the sink with a flange and a mounting ring. The old unit comes out, the flange is cleaned and sealed for the new one, and the drain and dishwasher hose are hooked back up. If the dishwasher drain is connected, the knockout plug on the new unit must be removed.
The unit is wired to a switch or plugged into an outlet under the sink. Disposals are rated by horsepower, and a larger one runs smoother and handles more. Ask about noise levels, jam-resistant designs and warranty.
Most dishwashers drain into the disposal or into a branch tailpiece on the sink drain. A high loop or air gap in the hose stops dirty sink water from flowing back into the dishwasher. If the dishwasher does not drain, the disposal inlet knockout may still be in place, or the hose may be clogged.
If you are replacing the unit, ask the plumber to check the dishwasher connection at the same visit. A hose that was clamped loosely for years is a common source of a slow drip under the sink.
Repair drips, weak flow, stuck shutoff valves and leaking outdoor spigots.
Clear kitchen, bath, laundry and main-line clogs and find out why they came back.
Fix a running, leaking or clogged toilet or replace it.
It is jammed. Turn off the power, use a hex key in the bottom to free the flywheel, remove the object and press reset.
Many last around eight to fifteen years depending on use and quality.
Grease, fibrous vegetables, coffee grounds, pasta and rice, bones and anything that is not food.
Yes, if grease and food solids build up in the drain past it. Running cold water while grinding helps.
Turn the disposal off, empty the cabinet and call the 24/7 line. A leak at the flange, the seals or a drain connection is often repairable, and a cracked housing means replacement.
Often yes. Share the brand and horsepower when you call, and ask the dispatcher to confirm it before the visit.
Press the reset button on the bottom and check the breaker. If it still hums or stays dead, a jam or a motor fault is likely.
Yes, that is part of a normal install. Mention the dishwasher when you call so the right parts are on hand.
Usually yes. It needs power under the sink, a drain connection and room in the cabinet. A plumber can check these.
Call and say what it is doing. The dispatcher will connect you with a local contractor.
Service area centered on Sun City West and nearby Maricopa County cities.